Frequently Asked Questions About Pellet Packaging Machine
May 07, 2022
1. The seal of the mold is not well sealed
The sealing performance of the mold seal is a common problem. First of all, we need to find it from a simple place to see if the temperature exceeds the sealing temperature of the packaging film. If it exceeds, check whether the working pressure of the abrasive tool has reached. If there is no problem, it is the mold. The teeth do not bite or the left and right pressures are different. There are two solutions: the first is to heat treatment, the second is to pressurize, and the third is to re-align the mold, and use one side as the standard, so that it can be aligned well.
2. Photoelectric problems
This problem also occurs more often. The photoelectric problem is usually mainly manifested in that the length of the bag will change and the length will be different. Solution: When the film is walking, there is a mark on the film that is swept out, check whether there is wood or dust around the optometry eye, check whether the optometry eye sensitivity is adjusted, and check whether the film is variegated by harmful optometry. , If there is, you must look for a factor that is free of variegation. If you can't find it, your packaging film can be thrown into the trash.
3. The temperature cannot rise
This problem is easy to distinguish, but it is quite valuable for friends. First, you must check whether the fuse is broken or not. Check whether the car relay is broken. Use a multimeter to understand it. If you don’t have a multimeter, use a test pen. , If it is not bad, the next stage is to check whether the wiring of the heating rod is loose or not. If not, take out the wire of the heating rod and check the resistor. If the resistor is infinite, the heating rod will be OVER. If I don't have a universal watch, I'll try changing them one by one. In other words, the thermal resistance is damaged. This problem is very easy to distinguish. Either the leftmost message on the temperature control meter displays a 1 word, or the temperature is always vibrating again. Immediately replace the thermal resistance can be dealt with.
4. The temperature is difficult to control
There are two reasons for this problem, one is that the temperature control meter is broken, and the other is that the automobile relay is broken.
5. The main purpose of the granule packaging machine
The granule packaging machine is mainly used for the following fine-grained materials with good circulation: soap powder, seeds, edible salt, concentrated feed, chicken essence, dry seasoning, white sugar, etc. , The detailed trademark logo can be obtained by using the packaging products printed with the optical logo.
